Products		Rubidium Series 1 & 3: Module SI

Manual: pdf-file

IRIG-B changeover and monitoring module H1-Module

RUBIDIUM SI Module:

The Alpermann+Velte Rubidium series "SI" module is an automatic switchover unit for two incoming IRIG-B signals. The SI module compares and contrasts two incoming Time Codes (IRIG-B) for indescribable differences, in real-time. The comparison of IRIG-Bs can also be checked with another reference time input (e.g. GPS/DCF signal, if available). The SI module is a must for all Time Code system setups where failure proof IRIG-B Time Code is a requirement.

With two of our Rubidium master Time Code generator modules "RUB GI", the SI allows for an easy plug and play setup of a redundant system. Our SI was designed with the GI modules in/outputs in mind, but of course the SI switchover module can also switch two incoming IRIG-Bs from other 3rd party (non-Rubidium series) Time Code devices.

In addition to switching two IRIG-Bs the SI module also distributes our special in-house designed RS 485 (e.g. from our GI module), which allows for completely redundant Time, Timer and Time Code systems.

Standard available functions:	SI
Switches two incoming IRIG-B Signals
Switches two incoming impulse telegrams
IRIG-B error detection (monitoring functions)
Distribution of RS 485 (master/slave)
Windows configuration and setup
Updateable firmware (flash memory)
GPI failure outputs
GPS/DCF signal reference input/distribution
TC_link output of status data

Rear-sided panel:

Specifications:

We reserve the right to modify specifications without notice.